Oki OKIPAGE 10i Service Manual page 107

Category LCD status
message
Controller
errors
Service Manual - OKIPAGE10i
Chapter 6 Troubleshooting Procedures
Problem or status
An error occurred in the controller.
Code Error
(nn)
On A failure occurred in the
controller. n = Exception Code
10 An error was detected by
program ROM check.
20 An error was detected by font
ROM check.
30 An error was detected by
resident RAM check.
40 An error was detected by
EEPROM check.
50 An error was detected by
optional software ROM check.
52 PS only can't happen.
53 PS only undefined sys call.
60 An error was detected by
program ROM check.
70 An error was detected by
program ROM check.
Remedy
- Turn the power off, then
back on to recover from
the error.
- If normal operation is not
recovered by this restart
procedure, use the
following remedial actions.
Replace the main control
board.
Replace the main control
board.
Replace the main control
board.
Replace the main control
board.
Replace the EEPROM or
main control board.
Check the optional
software ROM board for
proper connection or
replace it.
-Check the optional RAM
board for proper
connection.
-Check the mounting
position of short plugs and
additional RAM chips (see
Section 7.4).
-Replace the optional
RAM board.
-Check the fan motor for
proper connection and for
any presence of foreign
matter in the fan (see
Section 6.5-2-(6)).
-Replace the fan or the
main control board.
Page: 71