Table of Contents
Advertisement
CRS-180 70/140 MHz IF 1:1 Redundancy Switch
Modem and Switch Configuration
All configuration changes can only be made to the Online CDM‐570 and will
require the user to "Save Parameters to permanent storage" to
ensure the configuration change is also applied to the Backup CDM‐570.
3.4.2
Non-IP Redundancy Configuration
Setup of the CDM‐570 modems for 1:1 Redundancy, when the terrestrial data type is non‐
Ethernet (i.e. RS422, G.703), is as follows:
Step
Procedure
On both modems, Enable 1:1 Redundancy:
1
Redundancy Configuration
Connect all cables – including the control cable, IF cable and data 'Y'cables – to the modems
2
and the CRS-180.
Figure 3-2. CDM-570 CLI 1:1 Redundancy Configuration screen
Chapter 4. CABLES AND CONNECTIONS
1:1 Redundancy set to ENABLE.
3–9
Revision 8
MN/CRS180.IOM
Advertisement
Table of Contents
