Capturing A Call Sign - Icom IC-7100 Basic Manual

5
D-STAR OPERATION <BASIC>

Capturing a call sign

After you receive the repeater's signal, the calling sta-
tion's call sign can be captured by holding down the
Call Sign Capture key
quickly and easily reply to the received call.
1. Set the received call sign to the destination
Hold down (R) for 1 second.
AUTO TUNE
RX�CS
• After releasing, beeps sound, and the station call sign is an-
nounced if the RX>CS Speech function is set to ON in the
"SPEECH" Set mode.
(C) > SPEECH > RX>CS SPEECH
SET
• If you want to select another call sign in the RX history, ro-
tate [DIAL] while holding down
NOTE: When a received signal is weak, or during
DR mode scanning, the call sign may not be received
correctly. In that case, "--------" appears, an error
beep sounds, and a quick reply call cannot be
made.
2. Hold down [PTT] to transmit
• While holding down [PTT], the TX/RX indicator lights red.
NOTE: Push
AUTO TUNE
"FROM" on the DR mode screen to cancel the Call
Sign Capture mode, and return to the previous call
sign setting.
(R). Then you can
AUTO TUNE
RX�CS
(R).
AUTO TUNE RX�CS
(R) or (C), or touch
DR
RX�CS
AUTO TUNE
RX�CS
L eft D isplay
C enter
While receiving
While holding down
AUTO TUNE
After releasing
AUTO TUNE
Transmitting
5-6
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
When receiv-
ing a call from
"JG3LUK."
Beeps
(R)
RX�CS
JG3LUK
Appears af-
ter selecting
a call sign.
(R)
RX�CS