About "Ur?" And "Rpt?" Error Messages; D Shows "Ur; D Shows "Rpt?" Or "Rx; D Shows "L - Icom IC-7100 Basic Manual

About "UR?" and "RPT?" error messages

The transceiver includes a status message in the signal
received back from the access repeater, after transmit-
ting.
D Shows "UR?"
The call was successfully sent, but no station's signal
was received within 3 seconds.
The called station may have missed your call, so after
waiting for a while, try calling again.
D Shows "RPT?" or "RX"
The destination repeater was not found, there is a pro-
gramming error, or the destination repeater was busy.
When "RPT?" is displayed, after waiting for a while, try
calling again, because in a gateway call, your signal is
sent even if the destination repeater is busy.
NOTE: "RPT?" or "RX" is displayed when:
• The repeater call sign programming is in error.
• Your own call sign is not registered on a gateway re-
peater, or the registration contents is not matched.
• The destination call sign is not registered on a
gateway repeater, or the registration contents is not
matched.
• The destination repeater call sign is not registered
on a gateway repeater, or the registration contents
is not matched.
• The destination repeater cannot be accessed.
• A blank MY call sign memory is selected. ("RX" is
displayed)
D Shows "L"
While operating in the voice communication or low-
speed data communication mode through the internet,
some packets may be lost due to network error, or the
caller's signal is weak getting into the repeater. In such
a case, "L" is displayed to indicate that Packet Loss has
occurred.
When the transceiver receives corrupted data, and
misidentifies it as Packet Loss, "L" is displayed, even
if it is a Local area call.
D-STAR OPERATION <BASIC>
This means that your local area call was cor-
rectly sent from the "Hirano" repeater.
This means that your gateway call was correctly
sent from the "Hirano" repeater to the "Hama-
cho" repeater.
This means that your gateway call was sent
from the "Hirano" repeater to the "Hamacho" re-
peater, but the "Hamacho" repeater was busy
at the time.
"L" blinks
loss is occurring.
5-5
Indicates packet loss
while packet
5