Before First Applying Power; Tuning On The Power - Icom IC-7100 Basic Manual

3
BASIC OPERATION
Power ON
D

Before first applying power

Before turning ON your transceiver for the first time,
make sure all connections required for your system are
complete by reviewing them in Section 2 of this man-
ual.
After all connections have been made, set the [AF]
and [RF/SQL] (L) controls as shown in the illustra-
tion to the right.
L eft D isplay R ight
C enter
D

Tuning ON the power

Normal Power ON:
Push [PWR] (L) to turn ON the transceiver.
Power OFF:
Hold down [PWR] (L) for 1 second to turn OFF the
transceiver.
Partial Resetting
A partial resetting CLEARS the operating param-
eters and returns them to their default values (VFO
frequency, VFO settings, menu group's contents)
without clearing certain data.
(C) > Others > Reset > Partial Reset
SET
• During start-up, the transceiver displays "PARTIAL RE-
SET," then its initial VFO frequencies when resetting is
complete.
See the PDF type Full Manual's Section 19 for reset-
ting details.
(L)
The L, R, C or D in the in-
structions indicate the part
of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
NOTE: When turning OFF the power, the transceiver
memorizes the settings. Thus the transceiver restarts
with the settings before you turned OFF the power.
[RF/SQL] control: 12 o'clock
[AF] control: Max counterclockwise
PWR
AF RF/SQL
TX / RX
CLR
M-CH BANK
PBT RIT
RIT MENU
TUNER/CALL MIC/RF PWR
[PWR]
3-2
i7100
NB NR NOTCH SET AUTO TUNE RX
SPEED/PITCH P.AMP ATT DR QUICK XFC
Initial VFO display
CS SPEECH
�
MPAD