D Auto Tuning Step Function - Icom IC-7100 Basic Manual

3
BASIC OPERATION
Setting frequency (Continued)
D 1/4 tuning step function
(Mode: SSB-D/CW/RTTY)
The dial speed is reduced to
when the 1 ⁄ tuning function is ON, for finer tuning con-
4
trol.
1
You can set the ⁄ tuning function in each operating
4
frequency band.
This function is selectable only when the quick tuning
function is turned OFF.
Push (C) one or more times to select the
q
MENU
"M-2" screen (M-2 menu).
Touch [1/4]( D) to turn the
w
OFF.
• " " appears when the 1⁄4 tuning function is ON.
D Auto tuning step function
When you rapidly rotate the Dial, the tuning speed can
automatically accelerate, depending on the "MAIN DIAL
Auto TS" option in the "Function" Set mode.
Push (C) to enter the Set mode.
q
SET
Touch the "MAIN DIAL Auto TS" item of the "Func-
w
tion" Set mode.
Function > MAIN DIAL Auto TS
• If the specified item is not displayed, touch [Y] or [Z](D)
one or more times to select the page.
Touch the desired option to select
e
tuning speed acceleration, or to turn OFF the func-
tion.
• HIGH: When the tuning step is set to 1 kHz or small-
er steps, the tuning speed is approximately five
times faster.
When the tuning step is set to 5 kHz or larger
steps, the tuning speed is approximately two times
faster.
• LOW: Approximately two times faster
• OFF: Auto tuning step is turned OFF.
• If desired, touch the item for 1 second to open the Default
set window, then select the "Default" to reset to the de-
fault setting.
Push (C) to exit the Set mode.
r
SET
The L, R, C or D in the instructions indicate the
part of the controller.
L: Left side, R: Right side, C: Center bottom
D: Display (Touch screen)
1 ⁄ of the normal speed
4
1 ⁄ tuning function ON or
4
the HIGH or LOW
(default)
3-10
Touch [1/4]
¹⁄₄ tuning icon
Push SET
Touch
"Function"
Touch "MAIN
DIAL Auto TS"
HIGH (Default)