Controller - Function Display - Icom IC-7100 Basic Manual

Controller — Function display
q TX ICON
Indicates either the displayed frequency can be
transmitted, or not.
➥ " " appears while the operating frequency is in
an amateur band.
➥ " " appears while the operating frequency is
not in an amateur band. However, when the "Band
Edge Beep" item is set to "OFF" in the "Function"
Set mode (p. 6-5), "
> Function > Band Edge Beep
SET
"LMT" appears while the output power is de-
➥
creased because the Power FET's temperature
is high.
"HOT" appears while transmission is inhibited be-
➥
cause the Power FET's temperature is too high.
w MODE ICONS (p. 3-17)
Displays the selected operating mode.
➥
• "-D" appears when SSB data, AM data or FM data
mode is selected.
Touch to enter the Mode selection screen.
➥
• On the Mode selection screen, touch the block to se-
lect the operating mode.
e PASSBAND WIDTH ICON
Graphically displays the passband width for twin
PBT operation and the center frequency for IF shift
operation.
r TONE SQUELCH/DIGITAL SQUELCH ICONS
(Mode: FM)
➥ "TONE" appears when the repeater tone function
is ON. (FM sec. 4)
➥ "TSQL" appears when the tone squelch function
is ON. (FM sec. 4)
➥ "DTCS" appears when the DTCS function is ON.
(FM sec. 4)
q w
" does not appear.
(FM sec. 5)
e r t y u i
(Mode: DV)
➥ "DSQL" appears when the digital call sign squelch
function is ON. (FM sec. 9)
➥ "CSQL" appears when digital code squelch func-
tion is ON. (FM sec. 9)
t IF FILTER ICON
Shows the selected IF filter.
➥
Touch to select one of three IF filter settings.
➥
• The selected filter passband width and shifting value
are displayed for 2 seconds in the window.
Touch for 1 second to display the "FILTER" screen
➥
to adjust the filter passband width.
➥ When the "FILTER" screen is displayed, touch for 1
second to return to the previous screen.
y QUICK TUNING ICON (p. 3-8)
Appears when the Quick tuning mode is selected.
• When "Z" is displayed, the frequency changes in preset
kHz or 1 MHz quick tuning steps.
• When "Z" is not displayed, the frequency changes in 10
Hz or 1 Hz steps.
u GPS ICON (FM sec. 10)
➥ Appears when valid position data is received from
a GPS receiver that is connected to the [DATA1]
jack.
➥ Blinks when invalid data is received from the GPS
receiver.
i SD CARD ICON
➥ " " appears when an SD card is inserted.
➥ " " and " " alternately blinks while accessing the
SD card.
1-7
PANEL DESCRIPTION
(FM sec. 5)
1