D Using The "Gateway Cq" (Gateway Call) - Icom IC-7100 Basic Manual

"TO" (Destination) setting (Continued)
D Using the "Gateway CQ" (Gateway call)
When "Gateway CQ" is selected in the "TO SELECT"
screen, the repeater to make a gateway CQ call can be
selected from the repeater list.
Example: Making a gateway CQ call to (Japan; Hama-
cho) from the "Hirano" repeater.
Push (C) to select the DR mode.
q
DR
Check whether or not "TO" is selected.
w
• If "TO" is not selected, touch the "TO" field.
Touch the "TO" field.
e
• The "TO SELECT" screen appears.
Touch "Gateway CQ."
r
• The "REPEATER GROUP" screen is displayed.
Touch the repeater group where your destination re-
t
peater is listed.
• Example: "11: Japan"
Touch the destination repeater.
y
• Example: "Hamacho"
• The transceiver returns to the DR mode screen, and
"Hamacho" is displayed in "TO."
After selecting a repeater, you can select another re-
peater preset in your transceiver by rotating [DIAL] or
[M-CH] (L).
Or, you can select another repeater group by rotating
[BANK] (L).
D-STAR OPERATION <BASIC>
L eft D isplay
C enter
"TO" is selected.
"Hamacho" is set in "TO."
5-15
The L, R, C or D in the
R ight
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
Touch
"TO."
Touch
"Gateway CQ."
Touch the re-
peater group
( Example:
"11: Japan")
Touch the desti-
nation repeater
( Example:
Hamacho)
5