Icom IC-7100 Basic Manual page 90

6
SET MODE
Set mode items and Default settings (Continued)
NOTE: The default settings shown below in bold are for the USA version.
The default settings may differ, depending on your transceiver version.
Connectors
USB Audio SQL
ACC/USB Output Select
ACC/USB AF Level
ACC/USB IF Level
ACC MOD Level
DATA MOD Level
USB MOD Level
DATA OFF MOD
DATA MOD
External Keypad
VOICE
KEYER
RTTY
CI-V
CI-V Baud Rate
CI-V Address
CI-V Transceive
USB2/DATA1 Function
USB2 Function
DATA1 Function
GPS Out
DV Data/GPS Out Baud
RTTY Decode Baud
VSEND Select
9600bps Mode
In this item, set the external connector's options.
OFF (OPEN) or ON
AF or IF
0 %~50 %~100 %
0 %~50 %~100 %
0 %~50 %~100 %
0 %~50 %~100 %
0 %~50 %~100 %
MIC, ACC, MIC,ACC or USB
MIC, ACC, MIC,ACC or USB
OFF or ON
OFF or ON
OFF or ON
300, 1200, 4800, 9600, 19200 or Auto Sets the CI-V code transfer speed.
01h~88h~DFh
OFF or ON
OFF, RTTY Decode or DV Data
OFF, RTTY Decode, DV Data or GPS
OFF or DATA1 g USB2
4800 or 9600
300, 1200, 4800, 9600 or 19200
OFF, UHF or VHF/UHF
OFF or ON
6-8
Selects whether or not to output the audio from
the [USB] connector, according to the squelch
state (open or closed).
Sets the [USB] connector and the [ACC] socket
usage to received audio output or the IF output
for DRM (Digital Radio Mondiale).
Sets the audio output level at the [ACC] socket
and the [USB] connector.
Sets the IF output level at the [ACC] socket and
the [USB] connector.
Sets the input modulation level at the [ACC]
socket.
Sets the input modulation level at the [DATA]
jack.
Sets the input modulation level at the [USB] con-
nector.
Selects the connector(s) for the desired modula-
tion to input when the data mode is not used.
Selects the connector(s) for the desired modula-
tion to input when the data mode is used.
Selects whether or not to transmit voice memory
contents using the external keypad.
Selects whether or not to transmit keyer memory
contents using the external keypad.
Selects whether or not to transmit RTTY memory
contents using the external keypad.
Sets the transceiver's unique CI-V hexadecimal
address code.
Turns the CI-V Transceive function ON or OFF.
Selects the use of the COM port (USB2).
Select the use of the [DATA1] jack.
Selects whether or not to output the data to the
COM port (USB2) when data is input from a GPS
receiver through the [DATA1] jack.
Sets the DV or GPS data transfer speed
Sets the RTTY decode monitor speed.
Selects the band to use for the [ACC] socket's pin
7 (VSEND usage).
Selects whether or not to allow data transmission
at 9600 bps.