Section 3 Basic Operation; Power On; D Before First Applying Power; D Tuning On The Power - Icom IC-7100 Advanced Instructions

Previous view
3
BASIC OPERATION

Power ON

D Before first applying power

Before turning ON your transceiver for the first time,
make sure all connections required for your system are
complete by reviewing them in Section 2 of this man-
ual.
After all connections have been made, set the [AF]
(L) and [RF/SQL] (L) controls as shown in the illus-
tration to the right.
L eft D isplay R ight
C enter

D Tuning ON the power

Normal Power ON:
Push [PWR] (L) to turn ON the transceiver.
Power OFF:
Hold down [PWR] (L) for 1 second to turn OFF the
transceiver.
Partial Resetting
A partial resetting CLEARS the operating param-
eters and returns them to their default values (VFO
frequency, VFO settings, menu group's contents)
without clearing certain data.
(C) > Others > Reset > Partial Reset
SET
• During start-up, the transceiver displays "PARTIAL RE-
SET," then its initial VFO frequencies when resetting is
complete.
See page 19-3 for resetting details.
The L, R, C or D in the
instructions indicate the
part of the controller.
L: Left side
R: Right side
C: Center bottom
D: Display (Touch screen)
NOTE: When turning OFF the power, the transceiver
memorizes the settings. Thus the transceiver restarts
with the settings before you turned OFF the power.
[RF/SQL] control: 12 o'clock
[AF] control: Max counterclockwise
PWR
AF RF/SQL
TX / RX
CLR
M-CH BANK
PBT RIT
RIT MENU
TUNER/CALL MIC/RF PWR
[PWR]
3-2
i7100
NB NR NOTCH SET AUTO TUNE RX CS
�
SPEED/PITCH P.AMP ATT DR QUICK XFC
Initial VFO display
SPEECH
MPAD