Viewing The Configuration - Extron electronics MAV 44 Series User Manual

Operation, cont'd
Figure 3-18 — Example 3, final configuration, audio switcher

Viewing the configuration

The current configuration (all active ties) can be viewed using the front panel
buttons as follows:
1.
2.
3.
3-12 MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
The current configuration (figure 3-18) is now:
• Video —
(Video-only switcher) — Input 5 tied to output 1, output 3, and output 8
(Audio/video switcher) — Input 5 video tied to output 1, output 3,
output 4, and output 8
• Audio — (Audio/video switcher) Input 5 audio tied to output 3 and
output 8
Input 5 video tied
to outputs 1, 3, 4, and 8.
Input 5 audio tied
to outputs 3 and 8.
Input
5
1
3
Output
4
8
Select video, audio, or both to view by pressing the I/O button.
Press and release an input or output button.
a. Press and release an input button — All of the buttons for outputs that
are tied to the selected input light. If the Audio LED is flashing, it
indicates that there are audio-only ties (audio breakaway).
Allow the 5-second timeout to deselect the input buttons before you select an
output button. If an input button is still selected, the indications will not be as
described and you may inadvertently establish potential ties that could be
created by pressing the Enter button.
b. Press and release an output button — The button for the tied input and
all of the buttons for outputs that are also tied to the same input light. If
the Audio LED is flashing, it indicates that there are audio-only ties
(audio breakaway).
To see all ties of the current configuration, press and release each input or
output button, one at a time, with the Video LED and the Audio LED lit.
After approximately 5 seconds, the LEDs for the input and tied outputs go
out.
Video
Audio