Creating A Set Of Ties - Extron electronics MAV 44 Series User Manual

Plug in all system components and turn on the input devices (such as DVD
2.
players, laserdisc players, VCRs, and DSS receivers) and the output devices.
Set the input devices to output video using each device's own operating
3.
instructions.
4. Create a tie (see below). The selected input image should appear at the
selected output. If no image appears, see "Troubleshooting", on page 3-27.

Creating a set of ties

You can create a set of ties, changing the current configuration, by using the front
panel buttons. Change the current configuration as follows:
1. On audio/video switchers, select to configure video, audio, or both by
pressing the I/O button as necessary.
Select the desired input and output(s) by pressing the input and output
2.
buttons.
Press and release the Enter button.
3.
4. Repeat steps 1 through 3 to create additional ties until the desired
configuration is complete.
•
•
•
•
•
•
•
Only one video input and one audio input can be tied to an output.
If a tie is made between an input and an output, and the selected output
was previously tied to another input, the older tie is broken in favor of the
newer tie.
Output LEDs light when an input is selected to indicate current ties.
Press and release the associated output buttons to clear unwanted outputs.
If, when you are configuring video and audio ties, the Audio LED blinks
and the Video LED is on after you have selected an input or output, the
LEDs indicate audio breakaway, meaning that the audio ties are not the
same as the video ties for that input.
If an input with no tie is selected, only that input's LED lights.
As each output is selected, the associated output LED blinks to indicate a
tentative tie until you press the Enter button or the 5-second timeout
expires. LEDs for output(s) that were already tied to the input light
steadily. Outputs that are already tied can be left on, along with new
blinking selections, or toggled off by pressing the associated output
button.
If you inadvertently press the wrong input or output button, wait
approximately 5 seconds. The input and output button selections time out
and are abandoned.
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation 3-7