Example 1: Create A Set Of Video And Audio Ties - Extron electronics MAV 44 Series User Manual

Operation, cont'd

Example 1: Create a set of video and audio ties

The following steps show an example in which input 5 is tied to outputs 3, 4, and 8.
The example shows the front panel indications that result from your actions.
1.
Figure 3-4 — Select video and audio
2.
Figure 3-5 — Select an input
3.
Figure 3-6 — Select the outputs
4.
Figure 3-7 — Press the Enter button
3-8 MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
This example assumes that there are no ties in the current configuration.
Audio/video switchers only — Select video and audio for the tie (figure 3-4).
The video LED lights when video is selected.
The audio LED lights when audio is selected.
Press and release the Input 5 button (figure 3-5).
Press and release the Input 5 button.
1 2 3 4
The Input 5 LED lights to indicate that input 5 is selected.
Press and release the Output 3, Output 4, and Output 8 buttons (figure 3-6).
The entire set of ties can be canceled at this point by waiting for the 5-second
input/output button timeout to occur.
Press and release the Output 3, 4, and 8 buttons.
OUTPUTS
2 4
1 3
The LEDs blink to indicate that the selected input will be tied to these outputs.
= Blinking LED
Press and release the Enter button (figure 3-7).
Press the Enter button to The selected input's and the selected outputs'
confirm the configuration LEDs light steadily for approximately 1
change. second to indicate the tie and then go out.
INPUTS
5
ENTER
Press the button to cycle
through the selections.
I/O
VID
AUD
INPUTS
5 6 7
7
5 6
OUTPUTS
3 4 8
1 second
8
8