Page 2
Precautions Safety Instructions • English Warning This symbol is intended to alert the user of important Power sources • This equipment should be operated only from the power source indicated on the product. This equipment is intended to be used with a main operating and maintenance (servicing) instructions power system with a grounded (neutral) conductor.
Using the command/response table ... 4-3 Symbol definitions ... Windows-Based Program Control Installing the software ... 4-4 Using the software ... 4-6 Using the help system ... 4-6 MAV 62 Matrix Switcher• Table of Contents ... 1-2 ... 3-2 ... 3-6 ... 4-1 ... 4-4...
... A-5 Cables ... A-5 All trademarks mentioned in this manual are the properties of their respective owners. MAV 62 Matrix Switcher • Table of Contents MAV 62 Matrix Switcher ... A-1 68-301-01 Rev. E Printed in the USA 04 03...
RS-232 control — The operator can control the MAV 62 from a remote computer or other host using an RS-232 link on the Remote port. RS-232 control uses Extron’s Simple Instruction Set ™...
Introduction, cont’d Rack mount option — The MAV 62 is 1U high and a half-rack width wide. It can be installed on a standard rack shelf using an Extron 1U Shelf Rack, part # 60-190-01. Auto-switching power supply — An internal power supply with an IEC connector makes power cord connection easy.
All connectors are on the rear panel. Depending on the model of the switcher, the type and layout of the connectors on the rear panel will vary. Figure 2-2 shows the rear panel of the MAV 62 S-video switcher. Figure 2-3 shows the rear panel of the MAV 62 composite switcher.
Composite video input connectors — Connect composite video sources to these female BNC connectors. The MAV 62 switchers do not alter the video signal in any way. The signal output by the switcher is in the same format as the input.
If no external sync timing source is connected to the switcher, switching occurs immediately. MAV 62 Matrix Switcher • Installation or a touch control panel, to the MAV switcher via this 9-pin D connector...
Installation, cont’d MAV 62 Matrix Switcher Chapter Three Operation Front Panel Controls and Indicators Front Panel Operations Memory Troubleshooting — If no image appears MAV 62 Matrix Switcher • Installation...
You cannot create a tie from the front panel if the MAV 62 is in audio gain and attenuation mode (if the I/O LED is blinking). If the I/O LED is blinking, press and hold the I/O Conf/Save button until the I/O LED goes out.
When power is removed and restored, the audio level settings are retained. Viewing and adjusting an audio level See figure 3-4 and figure 3-5 and the following steps for an example of viewing and adjusting the audio level on a MAV 62 switcher. +8dB LED key:...
Ensure that the proper signal format is supplied. Check the cabling and make corrections as necessary. Call the Extron S Sales & Technical Support Hotline if necessary. MAV 62 Matrix Switcher • Operation CONF./SAVE CONF./SAVE MAV 62 Matrix Switcher Chapter Four...
When a local event, such as a front panel operation or error condition, occurs, the switcher responds by sending a message to the host. The switcher-initiated messages are listed below: (C) Copyright 1996, Extron Electronics MAV 62, Vx.xx Out1 Inn All Out2 Inn All The switcher issues the copyright message and the input selected message when it first powers on.
By default, the Windows installation creates a C:\UNIVSW folder and places two icons (Universal Switcher Control Program and Universal Switcher Help) into a group named “Extron Electronics”. MAV 62 Matrix Switcher • RS-232/Remote Control MAV 62 Matrix Switcher • RS-232/Remote Control...
• From within the Windows-based switcher control program, press the F1 key. Figure 4-2 — Universal Switcher Control Program window MAV 62 Matrix Switcher • RS-232/Remote Control MAV 62 Matrix Switcher A ppendix A Specifications, Accessories, and Part Numbers...
Page 17
MAV 62 S-video ... 6 S-video Connectors MAV 62 Composite Video 6 BNC female MAV 62 S-video ... (6) 4-pin mini DIN female Nominal level ... 1V p-p for S-video, and for composite video 0.3V p-p for C of S-video Minimum/maximum levels ...
Included Parts Included parts MAV 62 6 x 2 video and audio matrix switcher MAV 62 6 x 2 S-video and audio matrix switcher 60-358-02 MAV 62 matrix switcher label MAV 62 matrix switcher User’s Guide MAV 62 Matrix Switcher • Accessories and Part Numbers...