Viewing A Configuration - Extron electronics DMS 1600 User Manual

Viewing a Configuration

The current configuration can be viewed using the front panel buttons. The View-only mode
prevents inadvertent changes to the current configuration. View-only mode also provides a
way to mute outputs (see
View the current configuration as follows:
1. Press the Esc button to clear any front panel button indications that may be lit.
2. Press and release the View button. All of the buttons light for outputs that are not tied.
3. Select the desired input or outputs whose ties you wish to view by pressing the input
and output buttons.
If you press an output button for which there are no ties, the output buttons light for all
outputs without ties.
NOTES:
•
•
Example 4: Viewing Ties
In the following example, the ties in the current configuration are viewed. The steps show
the front panel indications that result from your action.
NOTE: This example assumes that you have performed
Example 2
1. Clear all selections: Press and release the Esc button. The button flashes once.
2. Select View-only mode: Press and release the View button.
Until you select an input, only the buttons for untied outputs light.
1
3. Select an input: Press and release the input 5 button.
1
1
The output buttons for outputs that are not tied to
Input 5 are either unlit or background illuminated.
Muting and Unmuting Outputs
To see all ties of the current configuration, press and release each input and
output button, one at a time.
After 30 seconds of front panel inactivity, View-only mode automatically ends.
on page 24, and Example 3
Press the button. It lights.
C O N T R O L
ENTER PRESET VIEW ESC
2 3 4 5 6 7
Press the button. It lights.
2 3 4 5 6 7
The output buttons for outputs
that are tied to input 5 light.
2 3 4 5 6 7
DMS 1600, DMS 2000, DMS 3200, and DMS 3600 • Operation
on page 33).
Example 1
on page 25.
8 8 8 8 15 16 1 1 1 1 1 1 1 1 1 1
OUTPUTS
INPUTS
8 8 8 1 1 1 1 1 15 16 1 1 1
8 8 15 16 8 1 1 1 1 1 1 1 1
OUTPUTS
on page 23,
26