Furniture Mounting The Switcher - Extron electronics MAV 44 Series User Manual

or
#8 Screw (4 Plcs)
Each Side
Figure 2-1 — Mounting the switcher

Furniture mounting the switcher

The MAV Series switcher models can be mounted under a table or other horizontal
surface with an optional Extron under-desk mounting kit (part #70-222-01).
1. Secure the two table/wall mounting brackets to the switcher with the eight
machine screws provided in the kit (figure 2-1).
Hold the switcher with attached brackets against the underside of the desk or
2.
other furniture. Mark the location of holes for screws on the underside of the
desk.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4. Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
Align the installed screws with the slots in the mounting brackets, and place
5.
the switcher against the surface, with the screws through the bracket slots.
6. Slide the switcher slightly forward or back, then tighten all four screws to
secure it in place.
Mounting Screws (2 Plcs)
Rack-mount
Bracket
(Included)
T S
P U
IN
5
6
3
4
0. 3A
0V 1
0- 24
10 2
z
-6 0H
Table/ 50
Wall-mount
Bracket (Optional)
MAV 44 / 48 / 84 / 88 Matrix Switchers • Installation
Drill pilot holes
Each Side
3/32" (2 mm) dia.,
1/4" (6 mm) deep.
R
7
L
R
8
R L
5
L
R
6
R
L
3
L
R
4
R L S
U T
1
T P
L O U
R
2
R L
7
L
R
8
R L
5
L
R
6
R
L
3
L
R
4
R L
T S
1
N C P U
L
S Y R IN
2
L
IN
T
O U
S
U T 7
T P
O U 8
5
6
3
4
1
2
7
8
V
8 A
V 8
M A
2-3