I/O Selection And Audio/Video Controls And Indicators (Audio/Video Switchers) - Extron electronics MAV 44 Series User Manual

I/O selection and audio/video controls and indicators
(audio/video switchers)
I/O and Audio Setup button —
7
• Press and release — Pressing the I/O button cycles through video and
audio, video only, or audio only for input and output selection. See the
Video and Audio LEDs (
• Press and hold — The I/O button also serves as the Audio Setup
selection button. To enable the Audio Setup mode, press and hold the
Audio Setup button for about 2 seconds until the Audio Setup LED (
lights . In Audio Setup mode, you can view and/or change the current
audio level setting for each input. See "Adjusting input audio gain and
attenuation" on page 3-19.
Audio Setup mode times out after approximately 30 seconds of inactivity.
Alternate reset function — This button is also used to perform a system reset.
See "Resetting the system to factory defaults (audio/video switchers)" on
page 3-26.
Video/+dB LED and Audio/–dB LED —
8
• I/O selection — The Video and Audio LEDs indicate whether video and
audio, video only, or audio only will be selected using the input buttons
( ) and output buttons (
3
Pressing the I/O button advances through a cycle of video and/or audio
selections as shown on figure 3-3.
MAV SERIES
AV MATRIX SWITCHER
I/O
VID +dB
AUD -dB
AUDIO SETUP
Figure 3-3 — Video and/or audio selection cycle
• Audio Setup mode — The –dB and +dB LEDs indicate the polarity of the
audio level setting. See "Adjusting input audio gain and attenuation" on
page 3-19. Both LEDs light to indicate unity gain (0 dB).
Audio Setup LED — The Audio Setup LED lights red to indicate that the
9
switcher is in Audio Setup mode. See "Adjusting input audio gain and
attenuation" on page 3-19.
Alternate IR error function — The Audio Setup LED also indicates errors
when you use an IR 501 small matrix remote control. The LED lights for
approximately 1 second when the switcher receives an unexpected or
out-of-sequence IR command from the remote control. The switcher
otherwise ignores the command.
) for the sequence.
8
).
4
VID VID
+dB
AUD -dB AUD
Press
Default Video Only
= ON
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
VID VID
+dB +dB +dB
-dB AUD -dB AUD -dB
Press Press
Audio Only Video & Audio
= OFF
)
9
3-5