Example 3: Remove A Tie From A Set Of Ties - Extron electronics MAV 44 Series User Manual

Example 3: Remove a tie from a set of ties

This example shows two similar operations:
• Removing an audio tie from a set of ties on an audio/video switcher
• Removing a tie on a video-only switcher
The following steps show an example in which an existing tie is removed from the
current configuration. The example shows the front panel indications that result
from your actions.
This example assumes that you have performed example 1 and example 2.
1. Audio/video switchers only — Select audio only for the tie (figure 3-14).
The video LED is off when video is deselected.
The audio LED lights when audio is selected.
Figure 3-14 — Select audio only
2. Press and release the Input 5 button (figure 3-15).
Press and release the Input 5 button.
INPUTS
4 5 6
The Input 5 LED lights to
indicate that input 5 is selected.
Figure 3-15 — Select an input
3. Press and release the Output 4 button (figure 3-16).
Press and release the Output 4 button.
1 2
The Output 4 LED goes out to indicate that the selected input will be untied from
this output.
Figure 3-16 — Deselect the output
4. Press and release the Enter button (figure 3-17).
Press the Enter button to
confirm the configuration
change.
ENTER
Figure 3-17 — Press the Enter button
MAV 44 / 48 / 84 / 88 Matrix Switchers • Operation
Press the button to cycle
through the selections.
I/O
VID
AUD
1 2 3 4
On an audio/video MAV, the Output 3, Output 4, and Output 8 LEDs light to
indicate the ties created in example 1.
OUTPUTS
3 4 5
6
The selected input's LED and the remaining tied outputs' LEDs
light steadily for approximately 1 second to indicate the tie and
then go out. (The deselected output's LED is already out.)
INPUTS
5 3
1 second
OUTPUTS
5 6 7
7
8
OUTPUTS
4 8
8
3-11