Viewing A Configuration - Extron electronics DMS 1600 User Manual

Viewing a Configuration

The current configuration can be viewed using the front panel buttons. The View-only mode
prevents inadvertent changes to the current configuration. View-only mode also provides a
way to mute outputs (see
View the current configuration as follows:
1. Press the Esc button to clear any front panel button indications that may be lit.
2.
Press and release the View button. All of the buttons light for outputs that are not tied.
3.
Select the desired input or outputs whose ties you wish to view by pressing the input
and output buttons.
If you press an output button for which there are no ties, the output buttons light for all
outputs without ties.
NOTES:
Example 4: Viewing Ties
In the following example, the ties in the current configuration are viewed. The steps show
the front panel indications that result from your action.
NOTE:
1. Clear all selections: Press and release the Esc button. The button flashes once.
2.
Select View-only mode: Press and release the View button.
Until you select an input, only the buttons for untied outputs light.
1
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
"Muting and Unmuting
• To see all ties of the current configuration, press and release each input
and output button, one at a time..
•
After 30 seconds of front panel inactivity, View-only mode automatically
ends.
This example assumes that you have performed
example 3.
Press the button. It lights.
C O N T R O L
ENTER PRESET VIEW ESC
2 3 4 5 6 7
Outputs").
example
8 15 16
OUTPUTS
DMS 1600 and DMS 3600 • Operation
1, example 2, and
25