Power-Up Modes; Boot Mode - Toshiba T2150CD Series Manual

Set Password Again?
Press Y to run the TSETUP program and set a new password.
Press N to restart the computer.
NOTES
1. The password service diskette must be inserted in drive A,
otherwise the display will return to
inserted the diskette in drive A and the message still appears,
the password service diskette is faulty. In this case, contact
your dealer.
2. If the boot priority is set for the hard disk, press F10 and the
reset button to boot from the diskette drive.

Power-up Modes

The computer has two operating modes: boot mode and resume mode. You can set the mode
by pressing Fn + F3 to open the Pop-up window and, while holding down Fn, pressing F3
again to change the mode. You can also select the mode by choosing a setting in either the
TSETUP program or in MaxTime. See
details on setting the power-up mode.

Boot Mode

Boot mode is the standard operating mode for most computers.
In boot mode, the computer performs the following actions when you start the system:
Clears all programs and data from memory.
Runs a memory test and copies the operating system files from the hard disk to RAM.
Executes any commands in your CONFIG.SYS and AUTOEXEC.BAT files.
In boot mode, you must always save your work and exit the application you're using before
you turn the computer off. Any work you don't save before shutting the system off is lost.
NOTE
To run a self-test on the computer's system when you start the
computer in boot mode, hold down the space bar while you press
the power switch. Run the self-test after you install a memory
module or if you think there may be a problem with the system.
(Y/N)
Chapter 11, Setup and Password Security
. If you have
Password =
for