SCSI adapter
Flash memory
Network adapter
Installing the PCMCIA Card
Two PCMCIA connectors are located one above the other on the left side of the computer.
Both connectors are accessed from the same slot. You can install two Type II cards, one in
each connector, or one Type III card in the bottom connector.
To install a PCMCIA card, follow the steps below.
NOTE
Before you install the PCMCIA card, make sure the computer is in
boot mode.
1.
Turn off the computer and set it so that the left side faces you.
2.
Pull open the slot cover.
3.
Insert the PCMCIA card as shown in Figure 12-2. When the card is almost fully seated,
you will feel some resistance. Press gently to assure a firm connection, but do not force
the card into position.
4.
When the card is fully seated, an eject button will pop out. Arrows on the buttons
Figure 12-1 Opening the PCMCIA slot's cover
Figure 12-2 Installing the PCMCIA card