Table of Contents
Advertisement
CAUTION
Do not touch the connectors on the memory module or on the
computer. Debris on the connectors may cause memory access
problems.
8.
The module is held up by springs in the computer's socket. Gently push the module into
place until two latches close over each side.
9.
Fit the socket cover's latches into place and seat the cover.
10. Secure the two screws.
11. When you turn the computer on, it should automatically recognize the total memory
capacity. Verify that the added memory is recognized.
Removing Memory Module
To remove the memory module, make sure the computer is in boot mode then:
1.
Remove the battery and turn the computer off. Refer to
Power-Up
Modes.
CAUTION
Do not try to remove a memory module with the computer turned
on. You can damage the computer and the memory module.
2.
Remove all cables connected to the computer.
3.
Turn the computer upside down.
4.
Remove two screws securing the memory module socket cover.
5.
Slide your fingernail or a thin object under the notch on the cover and rotate the cover up
to remove it. Two latches hold the cover in place on the side away from the screws.
6.
Two latches on each side of the module hold it in place. Press these to the outside to
release the module. The side of the module away from the connectors will spring up. See
Figure 12-6 Inserting the memory module
Chapter 7, Power and
Advertisement
Table of Contents
