Table of Contents
Advertisement
indicate which is for the top connector (left button) and which is for the bottom
connector (right button).
5.
Close the cover.
6.
Small flaps in the cover open for each card installed (upper and/or lower) if the card
needs to be accessed by, for example, a communication line to a modem or Ethernet
adapter. If you need to access the card, simply open the corresponding flap.
After installing the card, check the configuration in the T2150CD series computer's TSETUP
program to make sure it is appropriate for your card. Refer to the Card Manager User's
Guide and to your card's documentation for setup information.
Removing the PCMCIA Card
To remove the PCMCIA card, follow the steps below.
NOTE
Before you remove the PCMCIA card, make sure the computer is
in boot mode.
1.
Turn off the computer.
2.
Open the slot cover.
3.
Press the eject button for the card you want to remove. The card will pop out slightly.
4.
Grasp the card and pull it out.
Figure 12-3 The card's slot cover
Figure 12-4 Removing the PCMCIA card
Advertisement
Table of Contents
