Table of Contents
Advertisement
When you use the diskette drive, connect the drive before you turn
on the computer. If the drive is connected after the computer is
turned on, the computer may not recognize the connection. In this
case you must restart the computer after the drive is connected.
Disconnecting 3 1/2" External Diskette Drive
When you have finished using the diskette drive, follow the procedures below to disconnect it:
1.
Wait for the indicator light to go out to make sure all diskette activity has stopped.
CAUTION
If you disconnect the diskette drive or turn off the power while the
computer is accessing the drive you may lose data or damage the
diskette or the drive.
2.
Press the release latches on either side of the connector attached to the computer and
pull out the connector.
3.
Close the cover to the diskette drive port.
4.
Press the release latches on either side of the connector attached to the diskette drive
and pull out the connector.
Opening the Display
The display panel can be rotated in a wide range of viewing angles for optimal viewing.
1.
Face the front of the computer and press the display latch.
2.
Lift the panel up and adjust it to the best viewing angle for you.
Figure 3-5 Opening the display
Advertisement
Table of Contents
