Rear Panel Layout; Dimension Digital Controller Rear Panel - Runco D-73d Ultra Installation & Operation Manual

Figure 2-5 shows the rear connector panel on the Dimension Digital Controller.
1
10
Figure 2-5. Dimension Digital Controller Rear Panel
1. MAIN POWER SWITCH
Disconnects or applies power to the Dimension Digital Controller.
2. 3D Sync Out
Not used. Connect the Active 3D Emitter to the projector.
3. TRIGGERS
Connection for up to three (3), 12-volt trigger-controlled devices such as retractable
screens or screen masks. Output current is limited to 250 milliamperes (mA).
4. USB
A standard, USB Series "B" connection to a personal computer, for performing
software upgrades and other service procedures.
5. RS-232 (To Accessory Box)
Reserved for future use.
6. Pri. Display Control
Connect this to the RS-232 input on the left-eye (top) optical engine on the D-73d
projector.
7. Sec. Display Control
Connect this to the RS-232 input on the right-eye (bottom) optical engine on the
D-73d projector.
8. IR
Wired input from a Niles- or Xantech-compatible, infrared (IR) repeater system. It is
a 3.5-mm, mini phono jack, wired as follows:
Ring = No connection
Tip = IR Input
Sleeve = Ground
9. RS-232 (PC / Control)
A female, 9-pin D-sub connector for interfacing with a PC or automation/control
system.
10. POWER INPUT (100 to 240 VAC)
Connect the Dimension Digital Controller to power here.
D-73d Series Installation/Operation Manual
2 3
TRIGGERS
3D SYNC
1 2
Compone Component / SCART ne ent / SCART
Y Y Video 1 Video 1
Pb Pb Pr Pr
DisplayPort
HD2 HD2
11 12 13
4 5 6
Pri. Display Control
RS-232
USB
3
To Accessory Box
Video 2 Video 2
Video 3 Video 3
HDMI 2 HDMI 2 HDMI 4 HDMI 4 HDMI 6 HDMI 6
14 15
13
System Overview

Rear Panel Layout

7 8 9
Sec. Display Control
RS-232
IR
PC / Control
HDMI Out
To Sec. Display
HDMI 8 HDMI 8 HDMI Out HDMI Out
Ethernet
Audio Only To Pri. Display
16 17 18 19