Front Riggings; Installing/Removing Front Riggings - Invacare Tracer SX5 User Manual

7 FRONT RIGGINGS

7 Front Riggings
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.
7.1

Installing/Removing Front Riggings


For this procedure refer to FIGURE 1.
Installing
1. Turn the front rigging assembly to the side.
2. Install the hinge plates on the front rigging assembly onto the hinge
pins on the wheelchair frame.
3. Push the front rigging assembly towards the inside of the wheelchair
until it locks into place.
 The footplate will be on the inside of the
wheelchair when locked in place.
4. Repeat this procedure for the other front rigging assembly.
5. To release the front rigging, push the front rigging release lever
inward, rotate front rigging outward.
Removing
1. Push the front rigging release lever inward
2. Rotate swingaway front rigging assembly outward.
3. Lift the swingaway front rigging assembly off the hinge pins.
®
Tracer SX5
Hinge
Pins
NOTE: Swingaway
footrest shown.
FIGURE 1
34
Front Rigging
Release Lever
Front Rigging
Assembly
Hinge
Plates
Installing/Removing Front Riggings
Part No. 1110550
Footplate