Recliner; Recliner Operation - Invacare Tracer SX5 User Manual

14 RECLINER

14 Recliner
WARNING
After any adjustments, repair or service and before use, make sure all attaching hardware is tightened securely - otherwise
injury or damage may occur.

14.1 Recliner Operation

WARNING
ALWAYS make sure that the wheelchair is stable in the full reclined (back at 180°) position and the full upright (back at 90°)
position BEFORE using the recliner option.
Anti-tippers MUST BE attached at all times.
ALWAYS engage both wheel locks while reclining or inclining (reverse recline) the wheelchair.
Make sure spring buttons of the spreader bar fully protrude out through the hole in the handle before using the wheelchair.
Make sure both back canes are at the same angle before releasing the handles of the recline mechanisms.
Mount the rear wheels in the Rear Wheel Offset Bracket only. NEVER reposition the rear wheels to the forward position,
stability of the wheelchair will decrease.
Before using the recliner option, the anti-tippers MUST be installed and properly adjusted. Refer to Installing/Adjusting the
Anti-tippers in Section 8 of this manual.
ALWAYS return the back to the upright position before lifting the wheelchair.
Assistants MUST be prepared to support the weight of the occupant when reclining, or returning the occupant of the
wheelchair to the full upright position. Make sure to use proper body mechanics (use your legs) or seek assistance if
necessary to avoid injury.
ALWAYS engage both wheel locks while reclining or inclining (reverse recline) the wheelchair.
®
Tracer SX5
64
Part No. 1110550