Removing/Installing The Spreader Bar - Invacare Tracer SX5 User Manual

14.4 Removing/Installing the Spreader Bar

WARNING
Make sure both release buttons of the spreader bar fully protrude out through the holes in the handle BEFORE using the
wheelchair.

For this procedure, refer to FIGURE 4 on page 69.
Removing
1. Push in release button on one side of existing spreader bar.
2. While holding spreader bar, pull the lock tube until the release
button is out of the handle of the back cane.
3. Drop the spreader bar to one side.
4. Repeat STEPS 1-2 on opposite end of spreader bar.
Installing
1. Push in release button on one of the lock tubes of the new/existing
spreader bar.
2. Insert lock tube into the handle of the back cane.
3. Ensure the release button fully protrudes out of the hole in the back
cane handle.
4. Repeat STEPS 1-3 on opposite end of spreader bar.
Part No. 1110550
Back Cane
Handle
Release
Button
FIGURE 4 Removing/Installing the Spreader Bar
69
14 RECLINER
Spreader Bar
Lock
Tube
®
Tracer SX5