Cisco WAP121 Administration Manual page 103

Wireless Settings
WPS Setup
STEP 3
STEP 4
NOTE
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
Configure the WPS instance parameters:
• WPS Instance ID—An identifier for the instance. As there is only one
instance, the only option is wps1.
• WPS Mode—Enables or disables the instance.
• WPS VAP—The VAP associated with this WPS instance.
• WPS Built-in Registrar—Select to enable the built-in registrar function.
When enabled, enrollees (typically WLAN clients) can register with the WAP
device. When disabled, the registrar functionality in the WAP device is
turned off and the enrollee needs to register with another registrar on the
network. In this case, another device on the network acts as the registrar and
the WAP device serves as a proxy for forwarding client registration requests
and the registrar's responses.
• WPS Configuration State—Whether the VAP will be configured from the
external registrar as a part of WPS process. It can be set to one of these
values:
- Unconfigured—VAP settings will be configured using WPS, after which
the state will be change to Configured.
- Configured—VAP settings will not be configured by the external
registrar and will retain the existing configuration.
Click Update. The changes are saved to the Running Configuration and to the
Startup Configuration.
The operational status of the instance and the reason for that status also display.
See Enabling and disabling WPS on a VAP, page 98
conditions that may cause the instance to be disabled.
The Instance Status area displays the WPS Operational Status as Enabled or
Disabled. You can click Refresh to update the page with the most recent status
information.
for information about
5
103