Cisco WAP121 Administration Manual page 121
Wireless-n access point with poe wireless-n selectable-band access point with poe
Hide thumbs
Also See for WAP121:
- Administration manual (179 pages) ,
- Quick start manual (13 pages) ,
- Datasheet (7 pages)
Table of Contents
Advertisement
Client Quality of Service
Class Map
Cisco Small Business WAP121 and WAP321 Wireless-N Access Point with PoE
When selected, all L3 packets will match an Match Every match condition.
•
Protocol—Use an L3 or L4 protocol match condition based on the value of
the IP Protocol field in IPv4 packets or the Next Header field of IPv6 packets.
If you select the field, choose the protocol to match by keyword or enter a
protocol ID.
-
Select From List—Match the selected protocol: IP, ICMP, IPv6, ICMPv6,
IGMP, TCP, UDP.
-
Match to Value—Match a protocol that is not listed by name. Enter the
protocol ID. The protocol ID is a standard value assigned by IANA. The
range is a number from 0 to 255.
•
Source IP Address or Source IPv6 Address—Requires a packet's source
IP address to match the address listed here. Select the checkbox and enter
an IP address in the text box.
•
Source IP Mask (IPv4 only)—The source IP address mask.
The mask for DiffServ is a network-style bit mask in IP dotted decimal format
indicating which part(s) of the destination IP Address to use for matching
against packet content.
A DiffServ mask of 255.255.255.255 indicates that all bits are important, and
a mask of 0.0.0.0 indicates that no bits are important. The opposite is true
with an ACL wild card mask. For example, to match the criteria to a single
host address, use a mask of 255.255.255.255. To match the criteria to a 24-
bit subnet (for example 192. 1 68. 1 0.0/24), use a mask of 255.255.255.0.
•
Source IPv6 Prefix Length (IPv6 only)—The prefix length of the source IPv6
address.
•
Destination IP Address or Destination IPv6 Address—Requires a packet's
destination IP address to match the address listed here. Enter an IP address
in the appropriate field to apply this criteria.
•
Destination IP Mask (IPv4 only)—The destination IP address mask.
The mask for DiffServ is a network-style bit mask in IP dotted decimal format
indicating which part(s) of the destination IP Address to use for matching
against packet content.
7
121
Advertisement
Table of Contents
