Configuration Guide
(DWS-3024) #
Example #2: Set Interface LLDP Parameters
The following commands configure interface 0/10 to transmit and receive LLDP information.
(DWS-3024) #config
(DWS-3024) (Config)#interface 0/10
(DWS-3024) (Interface 0/10)#lldp ?
notification
receive
transmit
transmit-mgmt
transmit-tlv
(DWS-3024) (Interface 0/10)#lldp receive
(DWS-3024) (Interface 0/10)#lldp transmit
(DWS-3024) (Interface 0/10)#lldp transmit-mgmt
(DWS-3024) (Interface 0/10)#exit
(DWS-3024) (Config)#exit
(DWS-3024) #
Example #3: Show Global LLDP Parameters
(DWS-3024) #show lldp
LLDP Global Configuration
Transmit Interval............................ 30 seconds
Transmit Hold Multiplier..................... 8
Reinit Delay................................. 5 seconds
Notification Interval........................ 1000 seconds
(DWS-3024) #
Example #4 Show Interface LLDP Parameters
(DWS-3024) #show lldp interface 0/10
LLDP Interface Configuration
Interface
---------
0/10
TLV Codes: 0- Port Description,
(DWS-3024) #
62
© 2001- 2011 D-Link Corporation. All Rights Reserved.
Enable/Disable LLDP remote data change notifications.
Enable/Disable LLDP receive capability.
Enable/Disable LLDP transmit capability.
Include/Exclude LLDP management address TLV.
Include/Exclude LLDP optional TLV(s).
Link
Transmit
Receive
------
--------
--------
Down
Enabled
Enabled
2- System Description, 3- System Capabilities
Notify
TLVs
--------
-------
Disabled
Y
1- System Name
Mgmt
----