Example #3: Show Sntp Server; Example #4: Configure Sntp; Example #5: Configure Sntp Client Mode - D-Link DWS-3000 Series Configuration Manual

Configuration Guide

Example #3: show sntp server

(DWS-3024) #show sntp server
Server IP Address:
Server Type:
Server Stratum:
Server Reference Id:
Server Mode:
Server Maximum Entries:
Server Current Entries:
SNTP Servers
------------
IP Address:
Address Type:
Priority:
Version:
Port:
Last Update Time:
Last Attempt Time:
Last Update Status:
Total Unicast Requests:
Failed Unicast Requests: 361

Example #4: configure sntp

(DWS-3024)(Config) #sntp ?
broadcast
client
server
unicast

Example #5: configure sntp client mode

(DWS-3024) (Config) #sntp client mode broadcast ?
<cr>
(DWS-3024) (Config) #sntp client mode unicast ?
<cr>
(DWS-3024)(Config)#sntp broadcast client poll-interval ?
<6-10>
180 © 2001- 2011 D-Link Corporation. All Rights Reserved.
81.169.155.234
ipv4
3
NTP Srv: 212.186.110.32
Server
3
1
81.169.155.234
IPV4
1
4
123
MAY 18 04:59:13 2005
MAY 18 11:59:33 2005
Other
1111
Configure SNTP client broadcast parameters.
Configure the SNTP client parameters.
Configure SNTP server parameters.
Configure SNTP client unicast parameters.
Press Enter to execute the command.
Press Enter to execute the command.
Enter value in the range (6 to 10). Poll
interval is 2^(value) in seconds.