Cli Examples; Example #1: Show Port Security; Example #2: Show Port Security On A Specific Interface; Example #3: (Config) Port Security - D-Link DWS-3000 Series Configuration Manual

Configuration Guide

CLI Examples

The following are examples of the commands used in the Port Security feature.

Example #1: show port security

(DWS-3024) #show port-security ?
<cr>
all
<slot/port>
dynamic
static
violation

Example #2: show port security on a specific interface

(DWS-3024) #show port-security 0/10
Intf
------
0/10

Example #3: (Config) port security

(DWS-3024) (Config)
<cr>
(DWS-3024) (Config)
120 © 2001- 2011 D-Link Corporation. All Rights Reserved.
Admin Dynamic
Mode Limit
------- ----------
Disabled 600
Press Enter to execute the command.
Display port-security information for all
interfaces
Display port security information for a
specific interface.
Display dynamically learned MAC addresses.
Display statically locked MAC addresses.
Display the source MAC address of the last
packet that was discarded on a locked port.
Static Violation
Limit Trap Mode
--------- ----------
20 Disabled
#port-security ?
Press Enter to execute the command.
#port-security