Table 3. Quick Start Up User Account Management - D-Link DWS-3000 Series Configuration Manual

Quick Start up User Account Management
Quick Start up User Account Management
Table 3.
Command
show users
(Privileged EXEC Mode)
show loginsession
(User EXEC Mode)
users passwd <username>
(Global Config Mode)
write
(Privileged EXEC Mode)
logout
(User EXEC and Privileged
EXEC Modes)
Displays all of the users who are allowed to access the network-
ing device
Access Mode - Shows whether the user is able to change
parameters on the networking device(Read/Write) or is only
able to view them (Read Only).
As a factory default, the admin user has Read/Write access and
the guest user has Read Only access. There can only be one
Read/Write user and up to five Read Only users.
Displays all of the login session information.
Allows the user to set passwords or change passwords needed
to login
A prompt appears after the command is entered requesting the
user's old password. In the absence of an old password, leave
the area blank. The user must press Enter to execute the com-
mand.
The system then prompts the user for a new password; then a
prompt to confirm the new password. If the new password and
the confirmed password match, a confirmation message is dis-
played.
A user password should not be more than eight characters in
length.
This command saves passwords and all other changes to the
device.
If you do not save the configuration by entering this command,
all configurations are lost when a power cycle is performed on
the networking device or when the networking device is reset.
Logs the user out of the networking device.
1 Getting Started
Details
Unified Switch Installation 23