Table 4. Quick Start Up Ip Address - D-Link DWS-3000 Series Configuration Manual

Configuration Guide
Quick Start up IP Address
To view the network parameters the operator can access the device by the following three
methods.
•
Simple Network Management Protocol - SNMP
•
Telnet
•
Web Browser
NOTE:
Table 4.
show network
(User EXEC Mode)
network parms <ipaddr>
<netmask> [gateway]
(Privileged EXEC Mode)
24 © 2001- 2011 D-Link Corporation. All Rights Reserved.
Helpful Hint: The user should do a 'copy system:running-config
nvram:startup-config' after configuring the network parameters so that the
configurations are not lost
Quick Start up IP Address
Command
Displays the Network Configurations
IP Address - IP Address of the interface
Default IP is 10.90.90.90
Subnet Mask - IP Subnet Mask for the interface
Default is 255.0.0.0
Default Gateway - The default Gateway for this interface
Default value is 0.0.0.0
Burned in MAC Address - The Burned in MAC Address used for
in-band connectivity
Locally Administered MAC Address - Can be configured to allow a
locally administered MAC address
MAC Address Type - Specifies which MAC address should be used
for in-band connectivity
Network Configurations Protocol Current - Indicates which net-
work protocol is being used
Default is none
Management VLAN ID - Specifies VLAN ID
Sets the IP Address, subnet mask, and gateway of the router. The IP
Address and the gateway must be on the same subnet.
IP Address range from 0.0.0.0 to 255.255.255.255
Subnet Mask range from 0.0.0.0 to 255.255.255.255
Gateway Address range from 0.0.0.0 to 255.255.255.255
Details