Using The Cli To View The Ip Address - D-Link DWL-8500AP - AirPremier AG Wireless Switching 108 Dualband Access Point Administrator's Manual

D-Link Unified Access Point Administrator's Guide

Using the CLI to View the IP Address

The DHCP client on the Unified Access Point is enabled by default. If you connect the access
point to a network with a DHCP server, the AP automatically acquires an IP address. To
manage the access point by using the Administrator UI, you must enter the IP address of the
access point into a Web browser.
If a DHCP server on your network assigns an IP address to the access point, and you do not
know the IP address, use the following steps to view the IP address of the access point:
1. Using a null-modem cable, connect a VT100/ANSI terminal or a workstation to the
console (serial) port.
If you attached a PC, Apple, or UNIX workstation, start a terminal-emulation program,
such as HyperTerminal or TeraTerm.
2. Configure the terminal-emulation program to use the following settings:
-
-
-
-
-
3. Press the return key, and a login prompt should appear.
The login name is admin. The default password is admin.
After a successful login, the screen shows the (Access Point Name)# prompt.
4. At the login prompt, enter
Information similar to the following prints to the screen:.
30 © 2001-2008 D-Link Corporation. All Rights Reserved.
Baud rate: 115200 bps
Data bits: 8
Parity: none
Stop bit: 1
Flow control: none
get management
.