Hot-Plug Procedures; Hot-Plug Scsi Hard Drive; Scsi Hard Drive Blank - HP DL380 Generation 4 Maintenance And Service Manual

should only be used by qualified service personnel. This value should
always match the serial number sticker located on the chassis.
Press the Enter key to clear the warning.
4.
Enter the serial number and press the Enter key.
5.
Select Product ID.
6.
Enter the product ID and press the Enter key.
7.
Press the Esc key to close the menu.
8.
Press the Esc key to exit RBSU.
9.
Press the F10 key to confirm exiting RBSU. The server will automatically reboot.
10.

Hot-plug procedures

Hot-plug SCSI hard drive

To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
Determine the status of the hard drive from the hot-plug hard drive LEDs
1.
LEDs" on page 85).
Back up all server data on the hard drive.
2.
Remove the hard drive.
3.
To replace the component, reverse the removal procedure.

SCSI hard drive blank

To remove the component:
CAUTION: To prevent improper cooling and thermal damage, do not operate the server unless all bays
are populated with either a component or a blank.
("Hot-plug SCSI hard drive
Removal and replacement procedures 44