Pci Hot Plug Expansion Slot Cover - HP DL380 Generation 4 Maintenance And Service Manual

Remove the expansion board.
6.
To replace the component, reverse the removal procedure.

PCI Hot Plug expansion slot cover

NOTE: Hot-plug functionality is supported only under Microsoft® Windows® 2000 and Windows® 2003. Hot-
plug drivers are not required.
To remove the component:
CAUTION: If the operating system installed on the server does not support PCI Hot Plug functionality,
power down the server (on page 20) before removing expansion boards.
Extend or remove the server from the rack
1.
the server from the
Remove the access panel
2.
Open the PCI riser cage door.
3.
("Extend the server from the
rack" on page 20).
("Access panel" on page 22).
rack" on page 19,
Removal and replacement procedures 52
"Remove