Dimms - HP DL380 Generation 4 Maintenance And Service Manual

DIMMs

To remove the component:
Power down the server (on page 20).
1.
Extend or remove the server from the rack
2.
the server from the
Remove the access panel
3.
NOTE: The server ships with at least two DIMMs installed in DIMM slots 1A and 2A.
Remove the DIMM.
4.
CAUTION: Be sure to install DIMMs in the proper configuration. Refer to the Documentation CD.
CAUTION: Use only Compaq branded or HP DIMMs. DIMMs from other sources may adversely affect data
integrity.
IMPORTANT: DIMMs do not seat fully if turned the wrong way.
To replace a DIMM, align the DIMM with the slot and insert the DIMM firmly. When fully seated, the
DIMM slot latches lock into place. The following table lists all seven valid combinations of single-rank and
dual-rank DIMM configurations.
Configuration
1
2
3
4
5
6
7
rack" on page 20).
("Access panel" on page 22).
Bank A Bank B
Single
Single Single
Single Single
Dual
Dual Single
Dual Single
Dual Dual
("Extend the server from the
Bank C Notes
Single
Online Spare not supported
Online Spare not supported
Single Online Spare not supported
Online Spare not supported
Removal and replacement procedures 38
rack" on page 19, "Remove