Power Down The Server; Remove The Server From The Rack - HP DL380 Generation 4 Maintenance And Service Manual

Power down the server

WARNING: To reduce the risk of personal injury, electric shock, or damage to the
equipment, remove the power cord to remove power from the server. The front panel
Power On/Standby button does not completely shut off system power. Portions of the
power supply and some internal circuitry remain active until AC power is removed.
IMPORTANT: If installing a hot-plug device, it is not necessary to power down the server.
Back up the server data.
1.
Shut down the operating system as directed by the operating system documentation.
2.
If the server is installed in a rack, press the UID LED button on the front panel (1). Blue LEDs
3.
illuminate on the front and rear panels of the server.
Press the Power On/Standby button to place the server in standby mode (2). When the server
4.
activates standby power mode, the system power LED changes to amber.
If the server is installed in a rack, locate the server by identifying the illuminated rear UID LED button.
5.
Disconnect the power cords.
6.
The system is now without power.

Remove the server from the rack

To remove the server from an HP, Compaq branded, telco, or third-party rack:
Power down the server (on page 20).
1.
Extend the server from the rack (on page 19).
2.
Disconnect the cabling and remove the server from the rack. For more information, refer to the
3.
documentation that ships with the rack mounting option.
Place the server on a sturdy, level surface.
4.
Removal and replacement procedures 20