D-Link GO-DSL-N150 User Manual page 26

The following table describes the parameters of this page:
Field
Username
Password
Encapsulation
Bridge Interface
PPPoE
Connection
TCP MSS Option
Get IP Address
Static IP Address
IP Subnet Mask
Gateway
NAT
Dynamic Route
Direction
TCP MTU Option
Multicast
MAC Spoofing
After finishing, click SAVE to apply the settings of this PVC.
Enter the username for PPPoE dial-up, which
is provided by your ISP.
Enter the password for PPPoE dial-up, which
is provided by your ISP.
You can choose PPPoE LLC, PPPoE
VC-Mux, PPPoA LLC or PPPoA VC-Mux.
for You can choose Activated or Deactivated.
You can choose Always On
(Recommended), Connect On-Demand or
Connect Manually.
You can set a tcp mss value. The range is
from 100 to 1452. The default is 0.
You can choose Static or Dynamic.
You can enter the ip address for dial-up,
which is provided by your ISP.
You can enter the ip subnet mask provided by
your ISP.
You can enter the gateway ip for dial-up,
which is provided by your ISP.
Select it
Translation (NAT) function. If you do not
select it and you want to access the Internet
normally, you must add a route on the uplink
equipment. Otherwise, the access to the
Internet fails. Normally, it is enabled.
You can select RIP1, RIP2-B or RIP2-M.
You can select None, Both, IN Only or OUT
Only.
You can set a TCP MTU value. The range is
from 100 to 1500. The default is 0.
You can choose Disabled, IGMP v1 or IGMP
v2.
You can choose Enabled or Disabled.
23
GO-DSL-N150
Description
to enable Network
User Manual
Address