Latch/Unlatch RTP to rail
Step
1
Mounting screws must be installed at each end of the mounting rail, with additional screws approx.
every 8"(203mm) to prevent twisting of the rail.
2
Insert one side of DIN rail at A.
3
Insert other side of DIN rail at B, and push B over the rail to snap into place.
4
To remove, using slot screwdriver to lift C up gently (plastic is fragile) to disengage at B. Lift up and
over rail, then disengage at A.
Revision 5
9/03
Appendix B Installation of Remote Termination Panels (RTPs) - Latch/Unlatch RTP to rail
C
B
A
HC900 Hybrid Controller Installation and User Guide
Action
DIN rail
205