Honeywell HC900 Installation And User Manual page 77

Step
7 Connect wire shield to
grounding bars on top
and/or bottom of the Rack.
(Refer to Signal
Grounding, at the
beginning of this section,
for suggestions and
recommendations.)
8 Install I/O modules in
racks.
9 In each slot location not
occupied by an I/O
module, install a Filler
Block cover, Part number
900TNF-0001.
Revision 5
9/03
Procedure
Note:
Block assembly, except that it does not include the wire
terminating block (screw terminals). The Filler Block mounts in
the same manner as a Terminal Block (with captured screws at
top and bottom). Blank labels are provided for mounting in the
hinged door.
HC900 Hybrid Controller Installation and User Guide
I/O Module Installation and Wiring - I/O Installation Procedures
Comments
The Filler Block Cover looks much like an I/O Terminal
Reference
67