Honeywell HC900 Installation And User Manual page 112

Communications Installation - RS-485 Link to Operator Interface
Step
8
Select the Set Controller's Network Parameters button. Using the wizard (bottom radio button),
select the PC port to be used, then set the controller's new network parameters including IP address,
Subnet Mask (if other than the default), and Default Gateway IP address (if required, otherwise use
default). Refer to the HC900 Hybrid Control Designer User's Guide or its respective on-line help,
Utilities Worksheet - Set Controller's Network Parameters, for further details on this step.
Note: This step will require the controller to be placed temporarily in the Program mode. After the
new network parameters have been downloaded, the controller will conduct a Cold Start in its
transition to RUN. This will cause an initialization if there is a current configuration in the controller.
102
Procedure
HC900 Hybrid Controller Installation and User Guide Revision 5
9/03