RGBHV+Stereo to CatPro I/O Boards
(with RX Modules)
Applicability Notice
FIG. 53
An 8x8 RGBHV+Stereo to CatPro I/O board (shown below an RGBHV/HD-15 board and a stereo audio board)
This chapter pertains to Optima RGBHV+Stereo to CatPro input/output boards contained in
pre-engineered systems and custom systems. The table below shows the types of RGBHV+Stereo
to CatPro boards and their numbers.
RGBHV+Stereo to CatPro I/O Boards
Note: Specifications for the following boards are listed on page 94.
Configuration
The outputs on the Optima CatPro boards act as transmitters (TXs) and must be used in conjunction with
a CatPro RGBHV+Stereo Receiver (RX) Module FG1010-48-01 (see below) to make up a complete
system. For information on system setup, see page 100.
Note: Specifications for the RX module are listed on page 96.
FIG. 54
CatPro RGBHV+Stereo RX Module (rear view)
Optima Instruction Manual
6
7
5
4x8
8x8
RGBHV+Stereo to CatPro I/O Boards (with RX Modules)
8
Board Part #
FG1046-581
FG1046-575
catpro module
93