The Apweb Expansion Board - AMX Optima Instruction Manual

APWeb Expansion Board

The APWeb Expansion Board

The APWeb board has a TCP/IP Ethernet link connector, three indicator LEDs, and a Service switch.
FIG. 68
The APWeb board
TCP/IP Ethernet Link Connector
The APWeb board has a TCP/IP Ethernet (RJ-45) link connector that handles Ethernet 10/100
connections for 10 Mbps (megabits per second) and 100 Mbps. This connection is compatible with most
Ethernet based LANs.
Indicator LEDs
Above the TCP/IP connector are three green indicator LEDs, which indicate the following:
Ethernet Speed Indicator
Ethernet Link Indicator
Power Indicator
Note: The two small rectangular LEDs on the RJ-45 connector are not used on this product.
Service Switch
Below the TCP/IP connector is a Service switch that can be used to override system security if the
username and password are lost. The Instruction Manual – APWeb Interface includes instructions for
restoring the default username and password.
The switch can also be used to upgrade the APWeb board firmware. Do not attempt to update the
firmware unless directed to do so by technical support.
Caution: For security purposes, firmware upgrades cannot be performed remotely.
108
Ethernet Speed Indicator
Ethernet Link Indicator
Power Indicator
TCP/IP Ethernet Link Connector
Service Switch (set for normal function)
On – speed status is 100 Mbps
Off – speed status is 10 Mbps
On – link status is active
On – system is receiving power
Optima Instruction Manual