Attaching Cables - AMX Optima Instruction Manual

S-Video I/O Boards

Attaching Cables

When attaching S-Video input and output cables, refer to the sheet labeled "AutoPatch Connector Guide"
that ships with the system. The sheet shows where to attach each cable on the rear of each enclosure.
Follow the sheet exactly; the system was programmed at the factory to operate only as indicated on the
sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis 1 of 3") on a label
located on the left side near the power receptacle.
Optima S-Video boards are equipped with locking S-Video connectors. When used in conjunction with an
AMX AutoPatch manufactured S-Video cable, the connector and the cable lock into place. Standard
S-Video connectors may be used, but will not lock.
Signals may only be routed from the inputs on a board to the outputs on the same board because each
board has its own switching matrix.
To connect S-Video inputs and outputs:
1.
Fasten the cables onto the input or output S-Video connectors (FIG. 22).
FIG. 22
Fasten the cable onto the connector
Caution: To avoid damaging a locking S-Video connector or board, be sure to pull on the connector
housing instead of the cable.
To fasten a locking S-Video connector:
1.
Hold the connector at a slight angle to the right while pushing in.
Or
Pull back on the housing of the connector (FIG. 23) while pushing the connector in.
FIG. 23
Pull back housing to fasten the connector
To remove a locking S-Video connector:
1. Pull back on the housing of the connector, and pull the connector out.
44
Connector housing
Optima Instruction Manual