AMX Optima Instruction Manual page 157

Step 6 Red Note
Optima Instruction Manual
5a: Replace the three screws indicated on the bottom of the enclosure.
5
5b: Replace the expansion plate (requires two screws).
5a
FIG. 98
Replace 3 screws and expansion plate (2 screws)
6a: Replace the five screws indicated (four on the top and one on the side).
6
6b: Replace the rack ear (requires four screws).
6a
FIG. 99
Replace 5 screws and rack ear (4 screws)
Note: If a silver screw was removed from this hole in Step 1 of the "Removing I/O Boards" procedure
on page 146 or if a silver screw was shipped with the new board(s), be sure to screw it into the hole
circled in red in Step 6.
Appendix D – Adding or Replacing I/O Boards
Expansion plate
5b
Screw will fit into one of these 2 holes
Screw will fit into one of these 2 holes
Important: See Note below this
step regarding this screw.
6b
151