Attaching Cables - AMX Optima Instruction Manual

Attaching Cables

When attaching RGBHV/HD-15 input and output cables, refer to the sheet labeled "AutoPatch
Connector Guide" that ships with the system. The sheet shows where to attach each cable on the rear of
each enclosure. Follow the sheet exactly; the system was programmed at the factory to operate only as
indicated on the sheet. For multiple-enclosure systems, each enclosure will be numbered (e.g., "Chassis
1 of 3") on a label located on the left side near the power receptacle.
Signals may only be routed from the inputs on a board to the outputs on the same board because each
board has its own switching matrix.
To connect HD-15 inputs and outputs:
1.
Fasten the cables onto the input and output HD-15 connectors (FIG. 31).
FIG. 31
Fasten cable onto input or output HD-15 connector
HD-15 Pinout
Pinout information for the High Density HD-15 connector on the RGBHV/HD-15 I/O board is provided
below.
FIG. 32
RGBHV/HD-15 board connector pinout
Optima Instruction Manual
RGBHV/HD-15 Board Connector Pinouts
Input (VESA DDC Compliant)
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC in DDC
5. GND 10. GND
Output
1. Red 6. Red GND
2. Green 7. Green GND
3. Blue 8. Blue GND
4. ID Bit 9. +5 VDC out DDC 14. Vertical sync
5. GND 10. GND
Note: 55 mA supplied on output pin 9;
power draw not to exceed 50 mA per port.
RGBHV/HD-15 I/O Boards
11. ID Bit
12. DDC SDA
13. Horizontal sync
14. Vertical sync
15. DDC SCL
11. ID Bit
12. ID Bit
13. Horizontal sync
15. ID Bit
55