AMX Optima Instruction Manual page 27

DVI & HDMI additional
setup info
Optima Instruction Manual
6.
Apply power to the system according to the power-up procedure; see "Applying Power and Startup"
on page 33.
Note: We recommend using a surge protector and/or an AC line conditioner.
7.
Execute a test switch to be sure the system is working properly; see "Executing a Test Switch" on
page 36.
8. When the test switch works correctly, attach the remaining source and destination devices.
Installation Options
Additional installation tasks may include creating the following:
Custom channel names – See page 125 in "Appendix A – Managing Configuration Files."
Local presets – See page 126 in "Appendix A – Managing Configuration Files."
Global presets – See the Instruction Manual – BCS Basic Control Structure Protocol on the
AMX AutoPatch CD or at www.amx.com.
8x8 DVI Installation
If the system contains 8x8 DVI boards, additional setup information may apply.
If necessary, EDID Programmer software is available for re-programming DVI 8x8 boards
(see page 155). The EDID Programmer is located on the AMX AutoPatch CD (also available
at www.amx.com).
If using the four high-amperage output connectors on an 8x8 DVI board to power the first four
destination devices, see page 67.
8x8 HDMI Installation
If the system contains 8x8 HDMI boards, additional setup information may apply.
We recommend priming the system for InstaGate
reduce the HDCP latency (see page 81).
If necessary, EDID Programmer software is available for re-programming the HDMI boards
(see page 155). The EDID Programmer is located on the AMX AutoPatch CD (also available
at www.amx.com).
Installation and Setup
®
technology, which will significantly
21